Skil 3700 manual Attaching Blank Insert, Wings and blank insert must be installed

Attaching Blank Insert

!	WARNING	Wings and blank insert must be installed in
		order to use the table saw. Wings and blank

insert create the complete table and support the workpiece. Use the jigsaw insert without the jigsaw attached for the second blank insert. Never use the sander or router insert in table saw mode.

From among the loose parts, locate the following hardware. (Fig. 19)

Item	Description	Quantity
B1	Blank Insert	1
B2	Hex-head Screw	2
B3	Wing Nut	2
B4	Washer	2
B5	Retaining Bracket	1

To install a blank insert:

1.Attach retaining bracket B5 onto bottom of insert B1 using 2 hex-head screws B2, 2 washers B4, and 2 wing nuts B3 as shown (Fig. 19).

2.Lift the red latch lever Y located at front of the wing opening. The blank insert may be installed in the right or left wing. If you plan to use the router, note that the router can only be installed on the left wing.

3.Slip tabs on the edge of insert B1 into rear of wing opening (Fig. 20).

4.Lower front edge of insert into wing and lower the red latch lever Y. (Fig. 21)

FIG. 19

B2

B1 B5

B4

B3

B1

2 Y

X

FIG. 20

Y

FIG. 21

52.