254CHAPTER 9: BRIDGE-WIDE PARAMETERS

Field

Description

 

 

maxAge

Time period in seconds that the bridge uses to discard

 

stored configuration messages. The value is determined

 

by the root bridge. Compare with the bridgeMaxAge

 

field.

mode

Reflects that the bridge operates as a transparent bridge.

peakAddrCount

Reflects the highest number of addresses that have been

 

counted since the last address table flush. For the current

 

size of the address table, see the addressCount field.

priority

Configurable STP priority value for the bridge. The default

 

value is 0x8000. (0x signifies that 8000 is a hexadecimal

 

number.) The acceptable range is 0x0 – 0xffff (0 – ffff). To

 

configure a value, see “bridge spanningTree stpPriority”

 

later in this chapter. The bridge priority is included in the

 

bridge identifier and is considered the most significant

 

portion because it influences root bridge selection. A

 

lower priority increases the odds that the bridge will

 

become the root bridge.

rootCost

Value that reflects the total cost of the best path (lowest

 

value) from the bridge root port to the root bridge. The

 

value sums individual port path costs. To configure path

 

costs for ports on the bridge, see “bridge port stpCost” in

 

Chapter 10.

rootPort

Logical port with the best path from the bridge to the root

 

bridge.

stpGroupAddress

Address to which the bridge listens to receive

 

configuration messages and other STP information. To

 

modify the STP group address, see “bridge spanningTree

 

stpGroupAddress” later in this chapter.

stpState

Whether the Spanning Tree Protocol is enabled or

 

disabled for the bridge. The default value is disabled for all

 

switches except CoreBuilder 9000 modules. To configure

 

the bridge STP state, see “bridge spanningTree stpState”

 

later in this chapter. (STP is also configured on a

 

port-by-port basis. See “bridge port stpState” in

 

Chapter 10.)

timeSinceLastTopology

Time elapsed (in hours, minutes, and seconds) since STP

Change

last reconfigured the network topology.

topologyChangeCount

Number of times that STP has reconfigured the network

 

topology since you enabled STP or rebooted the system

 

(whichever is less).

topologyChangeFlag

Whether the bridge topology is currently changing

 

(true) or not changing (false)

 

 

Page 254
Image 254
3Com 3500 manual By the root bridge. Compare with the bridgeMaxAge, Field, PeakAddrCount, Priority, Become the root bridge