3Com 3500 manual Ipx route static, Node address in the format

618CHAPTER 20: IPX

ipx route static

✓3500

✓9000

9400

3900

9300

For CoreBuilder 9000: Applies to Layer 3 switching modules only.

Defines a static route.

Valid Minimum Abbreviation

ipx ro st

Important Considerations

■Before you define static routes on the system, define at least one IPX interface. See “ipx interface define” earlier in this chapter for more details.

■Static routes remain in the routing table until you remove them or until you remove the corresponding interface.

■If an interface goes down, routes are temporarily removed from the routing table until the interface comes back up.

■Static routes take precedence over dynamically learned routes to the same destination. You can have a maximum of 32 static routes.

Options

Prompt	Description	Possible Values	[Default]
IPX network	4-byte IPX address of the	0x1 – 0xfffffffe	–
address	interface. The address must be
	unique within the network.
Hops	Number of hops, or number of	1 – 15	1
	routers that must be crossed to
	reach the network segment.
Interface	Interface number to associate	■ A selectable	–
number	with the route. Depends on	IPX interface
	number of configured IPX	number
	interfaces.	■ ? (for a list of
		selectable IPX
		interfaces)

Node address 6-byte MAC address of the router that can forward packets to the segment. A node address of all zeroes (00-00-00-00-00-00) means that the route is connected directly to the router.

A node address – in the format xx-xx-xx-xx-xx-xx