ip ospf partition display 569
ip ospf partition
✓ 3500
✓ 9000
9400
3900
9300
display
For CoreBuilder 9000: Applies to Layer 3 switching modules only.
Displays OSPF memory allocation.
Valid Minimum Abbreviation
ip o pa d
Important Consideration
■See “ip ospf partition modify” later in this chapte r for information on
how OSPF memory allocation works and how t o modify it.Fields in the IP OSPF Partition Display
Field Description
Current partition
maximum size
OSPF memory partition upper limit as implemented at the last
system reboot.
Configured
partition
maximum size
Last value that you ent ered, which will beco me the current
partition maximum si ze after the next sys tem reboot.
■0 means that OSPF has been set to use the system memory
partition at the next reboot.
■1 means that OSPF has been set to use the default memory
allocation scheme, deriving its partition size from the
maximum size of the IP routing table at the next reboot.
■Any other value that does not equal the current partition
maximum size means that OSPF has been manually set to use
a specific maximum partition size at the next reboot.
Allocated
partition size
Module’s current working memory. OSPF dynamically allocates
memory in 100,000-byte chunks, up to the current partition
maximum size.
OSPF is using the
system partition
The administrator used the ip ospf partition modify
command to set a partition value of 0. The OSPF protocol is using
the system memory partition instead of its own partition, and
there is no specified OSPF memory limit.