3Com 3500 manual Flow Classifier Procedure, Custom Hex values for Protocol

qos classifier define 697

Prompt Description Possible Values [Default]

Custom	Hex values for
protocol	nonflow classifiers
hexidecimal	with the protocol
value (custom	custom type
nonflow
classifiers only)

■Ethertype hex value of 0x0 – 0xfffe

■DSAP hex value of 0x0 – 0xff

Note: You cannot enter 0xaa - 0xaa

■SSAP hex value of 0x0 – 0xff

Note: You cannot enter 0xaa - 0xaa

0x0

–

0x0

802.1p tag	For nonflow	■	Any combination of	–
	classifiers only, IEEE		priority tag values in the
	802.1p tag values		range of
			0 – 7
		■	all
		■ ? (for a list of possible
			values)

Flow Classifier Procedure

To accept the default or current values that appear in brackets [ ], press Enter.

1Enter a classifier number in the range of from 1 through 399.

Flow classifiers 20 and 23 are predefined for FTP and Telnet.

2Enter the classifier name (a unique name of up to 32 characters).

3Enter a cast type.

For a flow classifier, the options are unicast, multicast, and all.

4Enter the IP protocol type of TCP, UDP, or all.

5Enter the source IP address. The default value is 0.0.0.0.

6Enter the source IP address mask. The default value is 0.0.0.0.

7Enter the destination IP address.

8Enter the destination IP address mask.

9Enter the start of the TCP or UDP source port range, in the range of from 0 through 65535. The default is 0.

10Enter the end of the TCP or UDP source port range using a value of up to

65535.