340CHAPTER 14: VIRTUAL LANS (VLANS)

Field

Description

 

 

Origin

For all Layer 2 systems or switching modules, the VLAN origin is

 

always static, which indicates that the user created the VLAN.

 

For the CoreBuilder® 3500 or CoreBuilder 9000, the origin

 

indicates one of the following:

 

static — The VLAN was created statically (user-configured

 

by using the bridge vlan define command).

 

router — The VLAN was created automatically by a outer port

 

IP interface (of router origin). You create a router port IP

 

interface using the ip interface define command with

 

the interface type port. You cannot modify or remove a router

 

port VLAN.

 

GVRP — The VLAN was created dynamically from a GVRP

 

update (GVRP). You must enable the GVRP state for the entire

 

system as a bridge-wide parameter and for the participating

 

bridge ports as a bridge-port parameter.

Ports

Index numbers of the bridge ports that belong to the VLAN, or the

 

bridge port that belongs to the router port IP interface.

 

On the CoreBuilder 9000, the list of ports includes the front-panel

 

ports and the appropriate backplane ports. Example: On a 12-port

 

Layer 3 module, the list of ports includes ports 1 – 12 and port 13,

 

which is the module’s backplane port.

Type (VLAN

Either allOpen or allClosed. VLANs in allOpen mode share a

mode)

single address table for all configured VLANs; in allClosed mode,

 

each VLAN has its own unique address table. Standard bridging

 

rules apply based on the table addresses that are assigned to the

 

specific VLAN. A router port IP interface requires that you put the

 

system in allClosed mode.

VID

VLAN Aware Mode

(3500 and

9000 Layer 3)

Unique, user-defined integer (VLAN ID) that identifies this VLAN. It is used by management operations. You can assign or modify a VID that is associated with a static VLAN; you cannot modify the VID selected automatically after you define a router port IP interface, nor can you change the VID of the default VLAN. The default VLAN requires a VID of 1.

Whether the VLAN aware mode (tagging mode) is allPorts or taggedVlanPorts. The default for CoreBuilder 3500 Release

2.0or later is allPorts; allPorts is also the default as of CoreBuilder 9000 software Release 3.0. The value taggedVlanPorts is a compatibility mode for VLANs configured prior to CoreBuilder 3500 Release 2.0 and for VLANs configured on CoreBuilder 9000 Layer 3 modules prior to CoreBuilder 9000 Release 3.0.

Page 340
Image 340
3Com manual Origin, For the CoreBuilder 3500 or CoreBuilder 9000, the origin, Indicates one of the following, Port Vlan