3Com 3500 manual From which the probe packets, Defined on the system, Bytes Yes

480CHAPTER 16: INTERNET PROTOCOL (IP)

ip advancedTraceRoute

✓3500

✓9000

✓9400

✓3900

✓9300

For CoreBuilder 9000: Applies to Layer 3 switching modules only.

Traces a route to a host with one or more of the advanced traceRoute options.

Valid Minimum Abbreviation

ip advancedT

Important Considerations

■When you specify a host name, the host name and its associated IP address must be configured on a network name server. Also, you must add the IP address on the name server to the list of name server addresses that are associated with the network domain name. See “ip dns domainName” earlier in this chapter for more information.

■To interrupt the command, press Enter.

Options

		Possible
Prompt	Description	Values		[Default]
Host name or	Host name or IP address of the	■	A valid host	0.0.0.0
IP address	destination that you want to ping.		name
		■	IP address
Maximum ttl	Maximum number of hops that the	1 – 255 hops		30
	system can use in outgoing probe
	packets.
Destination	Destination (or base) UDP port	30000 –		33434
port	number that the system uses in probe	65535
	packets. Set the destination UDP port
	number to be very high to ensure that
	an application at the destination is
	not using that port.
Probe count	Maximum number of probes that the	1 – 10		3
	system sends at each TTL level.

Wait	Maximum amount of time that the
	system waits for a response to a
	probe.
Packet size	Number of bytes that the system
	sends in each UDP probe packet.
Source address	Source address other than the one
	from which the probe packets
	originate. This option is available if
	you have more than one IP interface
	defined on the system.

1 – 10 seconds		3
28	– 4096	28
bytes
■	n (no)	y

■y (yes)