3Com 3500 manual Procedure Flow Classifier

qos classifier modify 703

Prompt Description Possible Values [Default]

Start and end	For flow classifiers only, 0 – 65535
of TCP or UDP	start and end of the TCP
destination	or UDP destination port
port range	range.
	Specify as small a range
	as possible. The start
	value determines the
	end value.

0and 65535 (factory defaults), or current values

Additional	For flow classifiers only,	■	y (yes)	no (factory
filters	additional source,	■	n (no)	default)
(address/port	destination, and port
patterns)	information for this
	classifier. Each set of
	information counts
	toward the classifier
	limit.
Custom	For nonflow classifiers	■	Ethertype	–
protocol type	with the custom	■	DSAP/SSAP
(custom	protocol type.
nonflow
classifiers only)

Custom	Hex values for nonflow
protocol	classifiers with the
hexidecimal	custom protocol type.
value (custom
nonflow
classifiers only)
802.1p tag	For nonflow classifiers
	only, the IEEE 802.1p
	tag value

■	Ethertype hex value	0x0
	of 0x0 – 0xffff
■	DSAP hex value of	–
	0x0 – 0xff

■SSAP hex value of

	0x0 – 0xff	0x0
■	Any combination of	Current
	priority tag values in	value, if
	the range of 0 – 7	any
■	all

■ ? (for a list of selectable values)

Procedure (Flow Classifier)

1Enter the number of the classifier that you want to modify. The current numbers are shown in braces { }.

2To modify the name, enter the new name for the classifier.

The name that is associated with the classifier number that you specified is shown in brackets.