3Com 3500 manual System serialPort baudRate

system serialPort baudRate 97

2Enter the baud setting for the serial port. The system supports the following baud rates:

■19200

■9600

■4800

■2400

■1200

The system response depends on the cable status. If the cable is connected to the terminal port when you set the baud rate for that port, the system displays the following message:

Changing the baud rate may cause a loss of communication since you are currently connected via the serial port.

Are you sure you want to change the baud rate? (y/n):

■If you respond y (yes), the serial port’s baud rate is changed immediately, and you lose the ability to communicate to any devices connected to it until you adjust the device baud setting to match.

■If you respond n (no), the rate does not change, and the display returns to the previous menu.

Procedure (IP Interface)

1From the top level of the Administration Console, enter:

system serialPort baudRate

2Enter the baud setting for the terminal port.

After you select the new baud, the system displays the following message:

The baud rate will not change until the system is rebooted.

To have your change take effect without rebooting, perform this command via the serial port.

Are you sure you want to change the baud rate? (y/n):

■If you respond y (yes), the rate is not changed until you reboot the system.

■If you respond n (no), the rate does not change, and the display returns to the previous menu.