3Com 3500 manual Sent during a RIP Version 2 update, Mode On the selected interface All

Valid Minimum Abbreviation

458 CHAPTER 16: INTERNET PROTOCOL (IP)

ip rip For CoreBuilder 9000: Applies to Layer 3 switching modules only.

routeAggregation Sets the route aggregation mode.

Mode

✓ 3500	ip ri ro
✓ 9000
9400	Important Considerations
3900	■ Route aggregation mode determines which route table entries are
	sent during a RIP Version 2 update.
9300	■ If route aggregation mode is enabled, RIP-2 can function like RIP-1
	and “collapse” route table entries for all subnets of a directly
	connected network. For example, if route aggregation is enabled,
	and the system is advertising subnets 150.100.31.0 and
	150.100.32.0, only the entry for network 150.100.0.0 is sent in
	the update. With RIP Version 2, you must enable route aggregation
	mode if you want the interface to collapse the route table entries
	and function like RIP-1.
	■ If route aggregation mode is disabled (the default), a RIP-2
	update sends all routing table entries.
	Options
	Prompt	Description	Possible Values	[Default]
	IP interfaces	Index number of the interfaces	■ One or more	Previous
		for which you want to set the	selectable	entry, if
		route aggregation mode	interface indexes	applicable

Route	Whether you want to
aggregation	implement route aggregation
mode	on the selected interface

■all

■? (for a list of selectable interface indexes)

■disabled

■enabled

Current value