3Com 3500 manual Procedure Local Connection, Terminal

system serialPort terminalSpeed 93

system serialPort terminalSpeed

✓3500

9000

9400

3900

9300

Sets the terminal speed of your system serial port. The terminal speed is set by changing the terminal connection port baud rates.

Valid Minimum Abbreviation

sy se t

Important Considerations

■When you change the terminal port baud rate to something other than 9600, the new setting becomes the new default, even after you use the system nvData reset option.

■You must adjust the baud setting of your terminal or terminal emulator to match your system serial port’s baud rate before you can reestablish communication using the terminal port.

■You can use this command through the terminal serial port or through a Telnet session. However, if you change the terminal speed while you are in a Telnet session, you must reboot the system for the change to take effect.

Options

Prompt Description Possible Values [Default]

Terminal	Signal speed for the terminal
speed	connection

Confirmation Confirmation of terminal speed change

■ 19200 9600

■9600

■4800

■2400

■1200

■ y (yes) –

■n (no)

Procedure (Local Connection)

1To set the terminal speed for the serial port, from the top level of the Administration Console, enter:

system serialPort terminalSpeed