96CHAPTER 3: SYSTEM ENVIRONMENT

system serialPort baudRate

3500

9000

9400

3900

9300

Sets the baud rate of your system serial port.

Valid Minimum Abbreviation

sy se b

Important Considerations

The default setting for the serial port is 9600. You can change the setting to match the port speed on your terminal or modem.The default setting for the serial port is 9600. You can change the setting to match the port speed on your terminal or modem.

When you change the baud rate to something other than 9600, the new setting becomes the new default, even after you use the

system nvData reset option.

You must adjust the baud rate setting of your terminal or terminal emulator’s terminal interface processor (tip) to match your system serial port’s speed before you can reestablish communication using the terminal port.

You can use this command through the terminal serial port or through a Telnet session. However, if you change the terminal speed while you are in a Telnet session, you must reboot the system for the change to take effect.

Options

Prompt

Description

Possible Values

[Default]

New value

Baud rate for the serial port

 

connection

Confirmation Confirmation of baud rate change

19200

9600

9600

4800

2400

1200

y (yes)

n (no)

Procedure (Local Connection)

1To set the baud rate for the serial port, from the top level of the Administration Console, enter:

system serialPort baudRate

Page 96
Image 96
3Com 3500 manual Sets the baud rate of your system serial port, New value