189)Cable Loss
190)Cable Loss (lowest byte)
191)Average Cable Loss155 (highest byte)
192)Average Cable Loss
193)Average Cable Loss
194)Average Cable Loss (lowest byte)
195)Status Byte 1: ( 0b = Off , 1b = On)
(LSB) | bit 0 : Marker 1 On/Off |
| bit 1 : Marker 2 On/Off |
| bit 2 : Marker 3 On/Off |
| bit 3 : Marker 4 On/Off |
| bit 4 : Marker 5 On/Off |
| bit 5 : Marker 6 On/Off |
| bits |
196) Status Byte 2: (0b = Off, 1b = On) | |
(LSB) | bit 0 : Marker 2 Delta On/Off |
| bit 1 : Marker 3 Delta On/Off |
| bit 2 : Marker 4 Delta On/Off |
| bits |
197) Status Byte 3: ( 0b = Off , 1b = On) | |
(LSB) | bit 0 : Single Limit On/Off |
| bit 1: CW On/Off |
| bit 2: Trace Math On/Off |
| bits |
| bit 6 : Limit Type ( 0b = Single; 1b = Multiple) |
| bit 7 : Unit of Measurement (1b = Metric, 0b = English) |
198) Status Byte 4: | |
(LSB) | bit 0 - 1 : DTF Windowing Mode |
| bit: 1 0 |
0 0 - Rectangular (No Windowing)
0 1 - Nominal Side Lobe
1 0 - Low Side Lobe
1 1 - Minimum Side Lobe bits 2 – 7 : Not Used
199)Status Byte 5 (Cal Status): 00h : Calibration Off
01h : Standard Calibration On
02h : InstaCal Calibration On
03h : Standard FlexCal On
04h : InstaCal FlexCal On
200)VNA Signal Standard156 (higher byte)
201)VNA Signal Standard (lower byte)
(259 points * 8 bytes/point = 2072 bytes) | |
(517 points * 8 bytes/point = 4136 bytes) |
8 bytes for each data point
1. gamma157 (highest byte)
155Average Cable Loss is dB * 1000.
156Index into Standard List (use control byte #89 to retrieve the ASCII string name). “No Standard” sent as FFFEh
157Gamma data uses 1/10,000 units.
52 | Site Master PM |