Set Spectrum Analyzer Attenuation – Control Byte #111 (6Fh)
NOTE: This command exists for backward compatibility with the S33xC models. Features new to the S33xD models are not available here. To access the new features use Control Byte #143 (8Fh).
Description: Sets the attenuation for the Site Master Spectrum Analyzer mode. Send a value of 255 (FFh) to enable dynamic attenuation.
Automatic control couples the attenuation to the reference level. Note that setting the attenuation using this command automatically sets the attenuation coupling to “MANUAL”, thereby allowing it to be defined independently of the reference level.
Bytes to Follow: 1 byte
1)Attenuation Index 00h – 0 dB 01h – 10 dB 02h – 20 dB 03h – 30 dB 04h – 40 dB 05h – 50 dB
Site Master Returns: 1 byte
1)255 (FFh) Operation Complete Byte
224 (E0h) Parameter Error: Invalid Attenuation Value
238 (EEh) Time Out Error
Set Site Master VNA Segmented Limit Lines – Control Byte #112 (70h)
Description: Sets the position and On/Off status of the segmented limit lines for the VNA modes.
Site Master VNA modes support 5 limit segments. Each segment may have any finite slope and can be enabled and disabled independently of every other segment. The limit beep is enabled for all segments or no segments.
Limit segments are specified by their end points (starting and ending “x” and “y” values).
See control byte #29 (1Dh) response byte 60 to 129 for the current Site Master configuration.
Bytes to Follow: 14 bytes
1)Limit Number
2)Limit Line On/Off (01h = On, 00h = Off)
3)Starting X (highest byte)268
4)Starting X
5)Starting X
6)Starting X (lowest byte)
7)Starting Y (higher byte)
8)Starting Y (lower byte)
9)Ending X (highest byte)269
10)Ending X
11)Ending X
12)Ending X (lowest byte)
13)Ending Y (higher byte)
14)Ending Y (lower byte)
268Frequency in Hz or distance in 1/100,000 ft (or meters)
269Frequency in Hz or distance in 1/100,000 ft (or meters)
Site Master PM | 87 |
