266)VBW Setting (Frequency in Hz)
267)VBW Setting (Frequency in Hz)
268)VBW Setting (Frequency in Hz) (lowest byte)
269)OCC BW Method (0b if % of power, 1b = dB down)
270)OCC BW % Value23 (highest byte)
271)OCC BW % Value
272)OCC BW % Value
273)OCC BW % Value (lowest byte)
274)OCC BW dBc 24(highest byte)
275)OCC BW dBc
276)OCC BW dBc
277)OCC BW dBc (lowest byte)
278)Attenuation25 (highest byte)
279)Attenuation
280)Attenuation
281)Attenuation (lowest byte)
(LSB) | bit 0 : Marker 1 On/Off | |
| bit 1 : Marker 2 On/Off | |
| bit 2 : Marker 3 On/Off | |
| bit 3 | : Marker 4 On/Off |
| bit 4 | : Marker 5 On/Off |
| bit 5 | : Marker 6 On/Off |
| bits | |
299) Status Byte 2: ( 0b = Off , 1b = On) | ||
(LSB) | bit 0 | : Not Used |
bit 1 : Marker 2 Delta On/Off
bit 2 : Marker 3 Delta On/Off
bit 3 : Marker 4 Delta On/Off
bits
298) | Status Byte 3: (0b = Off, 1b = On) | |||
| (LSB) | bit 0 : Antenna Factor Correction On/Off | ||
|
| bits | : Detection Alg (00b = pos. peak 01b = average 10b = neg. peak) | |
|
| bits | : Amplitude Units (00b = dBm 01b = dBV 10b = dBmV 11b = dBuV) | |
|
| bit 5 | : Channel Power On/Off | |
|
| bit 6 | : Adjacent Channel Power On/Off | |
|
| bit 7 | : Not Used | |
299) | Status Byte 426 |
|
|
(0b = Off/Beep if data is BELOW line, 1b = On/Beep if data is ABOVE line) (LSB) bit 0 : Limit Type (0b = Single, 1b = Multiple)
bit 1 : Not Used
bit 2 : Single Limit On/Off
bit 3 : Single Limit Beep Level ABOVE/BELOW
bit 4 : Multiple Limit Upper Segment 1 Status On/Off
bit 5 : Multiple Limit Upper Segment 1 Beep Level ABOVE/BELOW27
bit 6 : Multiple Limit Upper Segment 2 Status On/Off
bit 7 : Multiple Limit Upper Segment 2 Beep Level ABOVE/BELOW
23% value is
24dBc value 0 – 120 dBc
25Value sent as ( value in dB * 1000 )
26For bits 2 and 0, 00=no limit, 10=single limit, 01=multiple limit, 11=multiple limit.
27Upper limits always trigger an error beep if data is ABOVE the limit segment, for example, this bit is always 1b.
Site Master PM | 19 |