Anritsu S332D, S331D manual Bit 0 C/I Measurement On/Off

316)Impedance Loss247 (higher byte)

317)Impedance Loss (lower byte)

318)Frequency Scale Factor248 (higher byte)

319)Frequency Scale Factor (lower byte)

320)Frequency Range Minimum249 (highest byte)

321)Frequency Range Minimum

322)Frequency Range Minimum

323)Frequency Range Minimum (lowest byte)

324)Frequency Range Maximum250 (highest byte)

325)Frequency Range Maximum

326)Frequency Range Maximum

327)Frequency Range Maximum (lowest byte)

328)Linked Trace Number (1-200)

329)Status Byte 9 (0b=Off, 1b=On)

(LSB)	bit 0 : C/I Measurement On/Off
	bits 1-3	: C/I Carrier Trace/Signal Type251
	bits 4-7	: Not Used

330)C/I Calculated Power252 (Carrier or Interference - NB FHSS253) (highest byte)

331)C/I Calculated Power (Carrier or Interference - NB FHSS) (lowest byte)

332)C/I Calculated Power (Carrier or Interference - NB FHSS) (highest byte)

333)C/I Calculated Power (Carrier or Interference - NB FHSS) (lowest byte)

334)C/I Calculated Power254 (Interference - WB FHSS255) (highest byte)

335)C/I Calculated Power (Interference - WB FHSS) (lowest byte)

336)C/I Calculated Power (Interference - WB FHSS) (highest byte)

337)C/I Calculated Power (Interference - WB FHSS) (lowest byte)

338)C/I Calculated Power256 (Interference - Broadband257) (highest byte)

339)C/I Calculated Power (Interference - Broadband) (lowest byte)

340)C/I Calculated Power (Interference - Broadband) (highest byte)

341)C/I Calculated Power (Interference - Broadband) (lowest byte)

342-400) Not Used

401-2004) Sweep Data

(401 points * 4 bytes/point = 1604 bytes)

4 bytes for each data point

1.dBm258 (highest byte)

2.dBm

247Value sent as (value in dB * 1000), valid values are 0 to 20 dB

248In number of Hz

249Scaled by Frequency Scale Factor (bytes 318-319)

250Scaled by Frequency Scale Factor (bytes 318-319)

251000b = NB FHSS, 001b = Carrier - WB FHSS, 010b = Carrier - Broadband, 111b = Interference

252Value sent as (value in dBm ￿ 1000) + 270,000

253If Status Byte 9, bits 1-3 equal 111b, then value will be calculated power for the interference trace as a NB FHSS signal. Otherwise, these bytes represent the calculated carrier power.

254Value sent as (value in dBm ￿ 1000) + 270,000

255If Status Byte 9, bits 1-3 equal 111b, then value will be calculated power for the interference trace as a WB FHSS signal. Otherwise, these bytes should be ignored.

256Value sent as (value in dBm ￿ 1000) + 270,000

257If Status Byte 9, bits 1-3 equal 111b, then value will be calculated power for the interference trace as a Broadband signal. Otherwise, these bytes should be ignored.

258Value sent as (Value in dBm * 1000 ) + 270,000

Site Master PM 69