6-6 Installationand Maintenance Volume
Octel 200/300 S.4.1 PB60019−01
Command BasicDefinition
TEL4x TEST LINE 4
Tests to see whether loop current is present on a specific port, where xis the
port number. The port number must be entered in decimals.
.This command is not used for DPNSS integration.
TEL5x TEST LINE 5
Tests tone reflection on one port, where xis the port number.
TE NET x y TEST NETWORK
Tests network routes to a network location, where xis the network location code
(optional), and yis the non-zero show digits entered. Tests all locations if no
network location is specified.
TE S TEST STATUS
Tests the temperatures and voltages for the Octel 200/300.
TE INT x y TEST INTEGRATION
Tells the integration card to run a link self-test, where xis the slot number, and
yis the unit number. Used only for message servers with integration cards.
.This command is not used for DPNSS integration.
T DNET TEST DNET
Use this command for Digital Networking to get a quick indication of the
general “health” of the configuration and hardware at the local and remote
cabinets.
TEXxyz TEST FAX
Perform a loopback test on the specified fax channels to verify that the fax
modems can send and receive fax data and to test the TDM bus connection.
Fax-modem data is sent across the Octel 200/300’s TDM bus, using one of the
fax channels as a sender and the other as a receiver. When this transaction is
completed, the fax application processor reverses the direction of the data flow
and repeats the transaction. In this command, xis the slot number, yis the fax
channel, and zis the fax channel. Refer to the Feature Description volume, Fax
Mail Plus chapter.
T SNMP TEST SNMP
An Octel 200/300 can inform an SNMP manager system when a qualified
hardware error is logged. This command tests the mechanism for an
Octel 200/300 to communicate to an SNMP manager system.
DEX x y Disk EXerciser
Tests all hard disk sectors forread errors, where xis the disk number, and yis
the region number.