6-20 Installationand Maintenance Volume
Octel 200/300 S.4.1 PB60019−01
.The SINGLE DIGIT MENU MAX DIGIT: and PREFIX DIGITS: fields are for a Single
Digit Menu that was created through the USER Table.Entries in these fields override any entries
made in INFORMATIONTable indexes 4 and 5, associated with the COS for the mailbox.
The FLAGS: field describes the state that the mailbox is currently in. The following definitions are for
the flags that might occur.
Screen Text Definition
LOG-ON — Mailbox holder currently logged on
SD-USE — Mailbox in use by SEND TASK
IS-FUL — Mailbox full
IN-RNG — Message waiting in range for this mailbox
HASMSG — Mailbox with a newly received message
MW−CAL — Message waiting call in progress (or shortly will be)
LMP-ON — Message waiting lamp turned ON
LP-CAL — Calling to turn ON/OFF lamp
FX−DEL — Fax delivery
LPRTRY — Lamp-message-waiting command retry
INTGIP — Integration lamp command in progress
.Distribution lists are not mailboxes and cannot be listed with this command.
Use LMxMas an extension of the mailbox configuration status command to list all the messages and
their status for a specific mailbox. To list message information for the mailbox, you must add the letter M
to the command. At the @ prompt, enter
LMxM Enter
For this command, xis the mailbox number.
An example of this extended command follows:
@L M 2000 M
STATUS MSG CRE STATUS MSG CRE STATUS MSG CRE STATUS MSG CRE
10 NEW 50B6 003E 20 SAV 501D 003E 48 LSN 5008 0002 10 NEW 5187 003E
10 NEW 51AC 003E 40 LSN 13FA 0000 40 LSN 5007 0000 40 LSN 3002 0000
FAX STATUS FAX STATUS FAX STATUS FAX STATUS
00 08 FAX 08 FAX 00
08 FAX 28 FAX PERSNL 00 18 FAX GROUP
The STATUS,MSG, and CRE columns display information about voice and fax messages. Todetermine
whether a message listed in these fields is a fax, refer to the FAX STATUS column of the corresponding
row.If a message is a fax, the fax status is described in the column.
For messages in a mailbox that uses the Serenade TUI, when a message is accessed (even if it is not
heard) the STATUSchanges from NEW to LSN. An example is when a mailbox holder has two new
messages and presses 5followed by 5immediately, both messages are marked as LSN.
For messages in a mailbox that uses the Aria TUI, the status changes from NEW to LSN only after the
message has been listened to for at least three seconds. Youcan change the three−second parameter by
changing Application Delay 145.