Procedures 12-65
Octel 200/300 S.4.1
PB60019−01
Copies software from the floppy disks to the hard disk. This step loads the
operating code into the files just created. You are prompted whento insert
each disk.
When the operating code is successfully copied, the Octel 200/300
prompts
The Octel 200/300 displays
PLEASE INSERT THE MODELS DISKETTE
*********************************
−−−− Press Return to continue −−−−
DCOPY F:MODELS H:MODELS
DCOPY F:MODDAT H:MODDAT
OPTION CONTROL CHIP UPDATED
RECOMBINE SUCCESSFUL!
*********************************************
F:loadcode IS NOW COMPLETE
.The system attempts to access system drives 1 and 2. The
following message appears if the system is configured for only
system drive 1. This message is correct only if system drive 2 is
not configured.
VCU XBOOT device invalid or not present; operation
skipped.
Copies the system prompts to hard disk.
The number of prompt disks may vary by language.
Restore System Software
26. @SUBMIT F:LOADCODE
Enter
27. Insert the Models Disk
Enter
28. Press twice.Enter
Restore System
Voice Prompts
29. Make sure you have a complete
set of prompt disks (for the
correct release level).
30. Check to make sure that the
revision level of the prompt
disks is the correct revision
level for the Octel 200/300
software release being restored.