Avaya Octel 200, Octel 300 1.2 USING INSTALL

1-4 Installationand Maintenance Volume
Octel 200/300 S.4.1 PB60019−01
1.2 USING INSTALL
The customer’s specific configuration needs should be determined and a configuration package
completed before the installation begins. Use the configuration package to answer each question in
the INSTALLprogram. A blank configuration package can be found at the end of the Understanding
Configuration chapter in the Configuration volume.
Follow the directions in the Installation and Maintenance volume, Installation chapter, Terminal
Communications section, to connect your terminal to the OctelR200/300.
Entering the INSTALL Program
Enter the maintenance level password to access the database. If this is a new installation and the
password has not been changed, enter the maintenance level password set by the manufacturer.
Caution!
Youshould change the manufacturer password to
ensure the security of the server. Refer to the
Configuration volume, Understanding Configuration
chapter, Using Security Procedures and Guidelines
section.
At the @ prompt enter:
INSTA or INSTAL Enter
The terminal displays the following messages:
@INSTA
−−−−−−−− SYSTEM INSTALLATION DIALOG −−−−−−−−
DAY MM/DD/YYYY HH:MM:SS SYSTEMNAME ID:XXXXX S/N:XXXXXX PBX:00
INSTALLthen identifies the type of installation.
-New installation.
INSTALLquestion 1 follows.
-Installation is in progress.
INSTALLcan continue, or it can start over.
-Message server has previously been installed.
To reinstall the message server,you must enter the maintenance password to initiate the reinstall.
The reinstallation begins by erasing all storedinformation and messages. Do not use
reinstall unless you areprepared to lose all messages.