INSTALL 1-27
Octel 200/300 S.4.1PB60019−01
1.5 EXITING BEFORE THE INSTALL IS COMPLETE
There are two ways that you can leave and re-access the INSTALL program, shown in the following
examples. The first example shows what to do if you make a mistake during INSTALL and, instead
of correcting it, you choose to exit and start over. The second example shows what to do if you are
interrupted during INSTALL and choose to stop temporarily and continue later.

Restarting INSTALL

If you make a serious mistake and you don’t want to fix it later, you can leave the program and start
over. At the point you wish to exit the program, type .E at the colon (:) prompt. The following
example, starting at question 1.c), shows how.
c) What is the SYSTEM ID number? (1−6 digits).
:555
d) How many (Octel 200/300) ports will be used? (1−8, empty line = 4)
:.E
EXITING INSTALL
WAIT...DONE.
−−−−−−−−−−−−−−−SYSTEM INSTALLATION SUSPENDED−−−−−−−−−−−−−−
@
When you want to return to the INSTALL program, type INSTA at the @ prompt, as shown below.
@INSTA
−−−−−SYSTEM INSTALLATION DIALOG
DAY MM/DD HH:MM:SS YYYY SYSTEM NAME ID:000
You have an installation already in progress.
Do you wish to start over with a NEW INSTALLATION?
(Y/N, empty line = NO, continue installation in progress)
Y:
CLEARINGALL TABLES...DONE.
INITIALIZINGALL USERDIRECTORIES...DONE.
1. SYSTEM PARAMETERS.
a) Select the MANUFACTURER NUMBER ..... etc.
All the information entered earlier has been cleared. Begin again with the first question. Refer to the
Answering Questions in INSTALL section.