9-14 Installationand Maintenance Volume
Octel 200/300 S.4.1 PB60019−01
4. Disengage the LIC from the motherboard by pivoting the plastic card ejectors at the top and bottom
of the front edge of the LIC.
5. Slide the LIC out of the card cage.
.Handle the LIC only by the top and bottom edges. Do not touch any components on the LIC.
6. Store the removed LIC in a static protection bag.

Installing LICs

Use the following procedure to install an LIC:
1. Put on an antistatic wrist strap. Connect it to an unpainted portion of the cabinet.
2. While holding the top and bottom edges of the card, slide it into the card cage.
3. Pivot the card ejectors, as needed, to grip the small flanges on the front edges of the card cage.
4. Firmly seat the LIC connectors into the motherboard by pressing the ejectors against the front edge
of the LIC. The ejectors will clip onto small pins on the LIC when the connectors are seated.
Caution!
Do not slam the LIC into the cabinet, as this could
damage the board or motherboard connectors.
Once the LIC is installed the red LED comes ON. When self-test diagnostics are complete the green
LED comes ON. When the LIC is initialized and ready for operation, the red LED goes OFF.
5. Initialize the ports by entering
CU x y
In this command, xis the slot, and yis the card being installed.
.Youcan also use the command TEC2xyto initialize the ports, where xis the first port
and yis the last port being forwarded.
6. Test the message server for correct operation.
7. Close and lock the door to the cabinet.
Integration Card Replacement
The Octel 200/300 integration cards installed in Shelf A are hot pluggable. That means you do not have
to turn OFF the message server to remove or install the cards.
.The message server must be restarted if an integration card is added or if the replacement card is
not the same as the card removed.
Caution!
No more than one integration card at a time can be
removed or installed with the power ON.