Hardware 2-5
Octel 200/300 S.4.1PB60019−01
Slot Number Cards
A1–A11 LIC, TLC, DAC, DLC16, ILC12, DTIC or integration cards
A1–A12 Fax card
A10–A12 LAN card
A12 EntryWorksACP card
A13 VCU
A14 CPU
A15 PSU
Refer to the Product Description and Administration volume, General Description chapter, General
Octel 200/300 Sizing Consideration and Capacity section, for additional information. Refer to the
Configuration volume, Slots Table chapter, for information about configuring the slots.
Octel 300 Shelves B and C
The slots in shelves B and C allow various configurations of Octel 300 hard disk drives and contain
the message server’s floppy disk device. The disk drive usage by slot number is as follows:
Slot Number Type of Disk Drive Installed
B1 Reserved for future use
B2 Worksfor Serenade disk drive
B3−B4 System/voice disk drives (data and voice storage)
B5 Floppy disk device
C1–C4 Voice disk drives (voice storage only)
Load the system/voice and voice disk drives into the slots in the following order: B3, B4, C1, C2,
C3, then C4.
-For a single-drive message server, load the system/voice drive in slot B3
-For a two-drive message server, load the system/voice drives in slots B3 and B4
-For a three-drive message server, load the system/voice drives in slots B3 and B4 and a voice
drive in slot C1; and so forth.
Other Octel 300 Components
Fans
The washable air filter is inside the front door of the cabinet. The air intake is from the front, and air
exhaust is from the rear and top.
Fan Tray
Four fans are located on a slide-out fan tray in the center of the cabinet, between shelves A and B.
The fan tray is a plug-in fan assembly used for system cooling. The fan assembly is accessible from
the front of the cabinet.
The four fans draw air through the front door air filter, and they exhaust from the top rear and top
sides of the cabinet. The fans use 12 volts and are powered from the +12 VM output of the PSU. The
fans are not sensitive to the input power to the cabinet.