Avaya Octel 200, Octel 300 .

12-42 Installationand Maintenance Volume

Octel 200/300 S.4.1 PB60019−01

The DSKMAP utility displays the last known status of all drives as recorded by the software in the Octel 200/300.

DSKMAP can be run from the hard disk or from the software disk. An example follows.

@DSKMAP

SLOT 1234

+−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−+

+−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−+

SLOT: 123 4

+−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−+

+−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−+

ID is the status of a drive and can be any of the following:

Status Explanation

ACTIVE

VALID

INVALID

UNKNOWN

ILLEGAL

ERROR

EMPTY

Drive is valid and currently operating.

Drive is approved for use, but requires rebuild to become active.

Drive configuration is not valid.

Drive configuration is valid, but does not match the rest of the system.

Drive is not an Octel 200/300 drive.

Drive is, or is considered to be, dead.

Drive slot is, or appears to be, empty.

.OCC MISMATCH on the screen indicates that the Option Control Chip (OCC) data on the system disk(s) does

not match the OCC data of the system EEPROM. Proper procedures should befollowed. Check the Hardware

Error Table to see if the OCC is faulty.

.ID MISMATCH on the screen indicates that the drive has previously been installed in a different drive slot. It

must be removed and installed in the correct slot, or a Restore procedure must be performed.

The DSKTST utility tests the drive slot specified, updates the last known status record of the software, and displays

the status. DSKTST can be run from the hard disk or from the software disk. An example of the screen and an

explanation of the entries follow.

@DSKTST C1

CURRENT STATUS

Slot Type ID Status

−−−−−−−−−−−−−−−−−−−−−−−−−−−−

C1Voice1−−EMPTY Not Cfgd