Installing & Setting Up the Driver (Windows)

Installing the OS-standard driver

The installation procedure will differ depending on your system.

Please proceed to one of the following sections, depending on the system you use.

• Windows XP/2000 users

(p. 136)

• Windows Me users

(p. 137)

• Windows 98 users

(p. 138)

Windows XP/2000 users

1.With the GS-10 disconnected, start up Windows.

Disconnect all USB cables except for a USB keyboard and USB mouse (if used).

2.Exit all currently running software (applications).

Also close any open windows. If you are using virus checking or similar software, be sure to exit it as well.

3.Before connecting the USB cable, switch the GS-10’s driver mode to “Standard.”

For instructions on switching the GS-10’s driver modes, refer to “Switching the Driver Mode” (p. 80).

4.With the power switch turned OFF, use the USB cable to connect the GS-10 to your computer.

5.Make sure that the GS-10’s OUTPUT LEVEL is set to the lowest setting, then switch ON the POWER switch.

The GS-10 will be detected automatically, and the driver will be installed.

6.When installation is complete, restart Windows.

Turn on power to your various devices in the order specified. By turning on devices in the wrong order, you risk causing malfunction and/or damage to other devices.

This unit is equipped with a protection circuit. A brief interval (a few seconds) after power up is required before the unit will operate normally.

Next, you need to make the driver settings (p. 141).

136

Page 136
Image 136
Boss Audio Systems GS-10 Installing the OS-standard driver, 136, When installation is complete, restart Windows