Installing & Setting Up the Driver (Macintosh)

OMS settings

If other MIDI devices are connected, you must turn off the power on all devices, and then make OMS settings according to the following procedure.

For more on connecting MIDI sound modules, refer to the owner’s manual for the MIDI sound module you are using.

1.Before connecting the USB cable, switch the GS-10’s driver mode to “Advanced.”

For instructions on switching the GS-10’s driver modes, refer to “Switching the Driver Mode” (p. 80).

2.With the power switch turned OFF, use the USB cable to connect the GS-10 to your computer.

3.Make sure that the GS-10’s OUTPUT LEVEL is set to the lowest setting, then switch ON the POWER switch.

4.In the “Opcode” folder, open the “OMS Applications” folder, and double-click

the “OMS Setup” icon.

fig.11-400

* The first time OMS is started up, a “Create a New Studio Setup” dialog box will appear. Click [OK]. If this is the second or later time, select “New Studio Setup” from the File menu.

fig.11-401

* If the “Apple Talk” dialog box appears, select [Turn It Off]. Then click [OK] in the dialog box that appears next.

fig.11-410

The “OMS Driver Search” dialog box will appear.

fig.11-420

Turn on power to your various devices in the order specified. By turning on devices in the wrong order, you risk causing malfunction and/or damage to other devices.

This unit is equipped with a protection circuit. A brief interval (a few seconds) after power up is required before the unit will operate normally.

148

Page 148
Image 148
Boss Audio Systems GS-10 owner manual 148, OMS settings