Boss Audio Systems GS-10 owner manual

5. Make sure that the GS-10’s OUTPUT LEVEL is set to the lowest setting, then switch ON the POWER switch.

USB composite device will be detected automatically, and the “Add New Hardware Wizard” dialog box will appear.

fig.11-280

6. Click [Next].

7. When “What do you want Windows to do?” appears, select “Search for the best driver for your device (Recommended)”, and click [Next].

fig.11-290

A dialog box like the one shown below will appear. fig.11-300

138

With the power switch turned OFF, use the USB cable to connect the GS-10 to your computer.

4.

Before connecting the USB cable, switch the GS-10’s driver mode to “Standard.” For instructions on switching the GS-10’s driver modes, refer to “Switching the Driver Mode” (p. 80).

3.

Exit all currently running software (applications).

Also close any open windows. If you are using virus checking or similar software, be sure to exit it as well.

2.

With the GS-10 disconnected, start up Windows.

Disconnect all USB cables except for a USB keyboard and USB mouse (if used).

1.

Windows 98 users

The USB composite device driver is installed first, then the USB audio device driver is installed. Use the following procedure to install the drivers.

■

Installing & Setting Up the Driver (Windows)

Turn on power to your various devices in the order specified. By turning on devices in the wrong order, you risk causing malfunction and/or damage to other devices.

This unit is equipped with a protection circuit. A brief interval (a few seconds) after power up is required before the unit will operate normally.