Chapter 9 Using the GS-10 Connected to a Computer Via USB

Enabling and Disabling the Direct Monitor Command

This setting determines whether or not the command (the Direct Monitor command) controlling the Direct Monitor (described later) setting is enabled.

1.Press [USB].

2.Press PARAMETER [ ] [ ] “Monitor Cmd” is

displayed.fig.

09-021d

3.Use the PATCH/VALUE dial to enable or disable the command.

Disable:

The Direct Monitor command is disabled, maintaining the Direct Monitor mode set by the GS-10.

Enable:

The Direct Monitor command is enabled, allowing the Direct Monitor mode to be switched from an external device.

* This is set to “Disable” when shipped from the factory.

4.Press [EXIT] to return to the Play screen.

Switching the Output Signals (Direct Monitor)

This setting determines whether or not the effect sound is output by the GS-10’s speakers or at the PHONES, OUTPUT L/R, or GUITAR AMP OUT jacks.

1.Press [USB].

2.Press PARAMETER [ ] [ ] so that “Dir

Monitor” is displayed.

fig.09-030d

3.Rotate the PATCH/VALUE dial to set On or Off.

On:

The effect sound is output. Set this to On when using the GS-10 as a standalone device, without connecting to a computer (no sound will be output if this is set to Off).

Off:

Set this to Off if transmitting audio data internally through a computer (Thru).

*This is set to “On” when shipped from the factory.

*If you are using the special driver, you can control Direct Monitor On/Off from ASIO 2.0-compatible application such as Cubase.

4.Press [EXIT] to return to the Play screen.

Setting the Output Mode

This selects whether the output is in stereo or if the effect sound and direct sound are output separately.

1.Press [USB].

2.Press PARAMETER [ ] [ ] so that “Output

Mode” is displayed.

fig.09-031d

3.Rotate the PATCH/VALUE dial to set the output mode.

Stereo (L/R):

Sounds are output in stereo.

Effect/Direct:

The effect sound and direct sound are output separately and independently.

* This is set to “Stereo (L/R)” when shipped from the factory.

4.Press [EXIT] to return to the Play screen.

Section 9

79

Page 79
Image 79
Boss Audio Systems GS-10 Enabling and Disabling the Direct Monitor Command, Switching the Output Signals Direct Monitor