Boss Audio Systems GS-10 Installing & Setting Up the Driver Windows Windows Me users, 137

Installing & Setting Up the Driver (Windows)

■Windows Me users

1.With the GS-10 disconnected, start up Windows.

Disconnect all USB cables except for a USB keyboard and USB mouse (if used).

2.Exit all currently running software (applications).

Also close any open windows. If you are using virus checking or similar software, be sure to exit it as well.

3.Before connecting the USB cable, switch the GS-10’s driver mode to “Standard.”

For instructions on switching the GS-10’s driver modes, refer to “Switching the Driver Mode” (p. 80).

4.With the power switch turned OFF, use the USB cable to connect the GS-10 to your computer.

5.Make sure that the GS-10’s OUTPUT LEVEL is set to the lowest setting, then switch ON the POWER switch.

Windows will detect the GS-10, and the “Add New Hardware Wizard” dialog box will appear.

fig.11-260

6.Make sure that Automatic search for a better driver (Recommended) is selected, and click [Next].

Driver detection will begin.

When the driver has been found, driver installation will begin.

Once the driver has been installed, a dialog box will inform you of this.

fig.11-270

7.Click [Finish].

8.Restart Windows.

→ Next, you need to make the driver settings (p. 141).

Turn on power to your various devices in the order specified. By turning on devices in the wrong order, you risk causing malfunction and/or damage to other devices.

This unit is equipped with a protection circuit. A brief interval (a few seconds) after power up is required before the unit will operate normally.

137