Chapter 6 Setting the External Pedal Functions

Manual Settings

Here, you can individually determine which controller is to control which parameter.

fig.06-013

5 2,4

1,3

1.Press [ASSIGN].

2.Press PARAMETER [ ] [ ] to select one of the Assigns from Assign 1–8.

3.Press [ASSIGN] to set the selected Assign to “On.” Each time [ASSIGN] is pressed it alternately switches this on and off. “ASSIGN” flashes in the display when the Assign is switched on.

* Always set any Assign that is not going to be used to “Off.”

4.Press PARAMETER [ ] [ ] to display the

following screens.

fig.06-020d

Target

Target value range: Min

Target value range: Max

Source

Source Mode

Active Range Low

Active Range High

5.Rotate the PATCH/VALUE dial to change the setting’s value.

6.Repeat Steps 4 and 5 as needed.

7.To use other Assigns, repeat Steps 2–6.

Even when using this procedure, the settings selected in Step 6 are maintained as is and carried over to the Quick Settings for the next effect.

8.To save the settings, use the Write procedure (p. 25). Press [EXIT] to return to the Play screen.

Target

fig.06-040d

This sets the parameter to be affected. The parameters that you can select as the target are shown below.

Effect On/Off

Effect’s Parameters

Switches on/off the effect indicated in the screen and controls the effect’s parameters.

MST: Patch Level

Controls the patch volume.

MST: Master BPM

Controls the Master BPM.

TUNER On/Off

Turns the tuner on and off.

Master BPM(Tap)

Controls the Master BPM using tap input.

Delay Time(Tap)

Controls the delay time using tap input.

Remote Strt/Stop

Starts and stops the recorder, sequencer, or other such device connected to the GS-10.

Patch Level Inc1

Increases the patch volume level in increments of 10 units.

Patch Level Inc2

Increases the patch volume level in increments of 20 units.

Patch Level Dec1

Decreases the patch volume level in increments of 10 units.

Patch Level Dec2

Decreases the patch volume level in increments of 20 units.

CH Select Inc

Switches the preamp channel in the following order: A B

C A...

CH Select Dec

Switches the preamp channel in the following order: C B

A C...

Section 6

61

Page 61
Image 61
Boss Audio Systems GS-10 owner manual Manual Settings, Target