Chapter 9 Using the GS-10 Connected to a Computer Via USB

Recording the GS-10’s Output with a Computer

Set your application (such as a sequencer) so that the audio input port it uses is the GS-10.

You can freely set the point in the signal chain from which to extract the signal to be sent to the computer with Effect Chain (p. 24). For example, by setting this so that the computer records the signals as they are at the beginning of the chain, you can record the sounds without any effects added while you listen to the performance with the effects applied from the speakers.

If you are using the software to send the audio data through, set Direct Monitor (p. 79) to Off.

Applying Effects with the GS-10 to a Computer’s Audio Playback

Set the audio output port used by applications to the GS-10.

You can use the GS-10 to add effects to audio data played back from the computer, and then record these sounds back to the computer.

Use this feature when you want to add effects to existing audio data.

1.Press [INPUT SELECT].

fig.09-060d

2.Use the PATCH/VALUE dial to select one of the following settings.

USB (Gtr/Mic):

Effects are applied to guitar and vocal sounds from the computer.

USB (Bass):

Effects are applied to bass sounds from the computer.

3.Press [EXIT] to return to the Play screen.

The flow of audio signals at this point is shown in the figure on p. 19, p. 20.

In this mode, set the software so that audio is not transmitted through (not set to Thru).

Running the GS-10 from a Computer

You can use USB MIDI to run the GS-10 from your computer.

When you set the GS-10 to the Advanced driver mode (p. 126, p. 146), the MIDI connectors used for operation of the GS-10 switches from MIDI IN/OUT connectors to the USB driver’s “GS-10 Control” MIDI ports. Set your editor and sequencer MIDI input and output ports to GS-10 Control.

For more on MIDI-related settings, refer to “Chapter 8 Using the GS-10 with External MIDI Devices Connected” (p. 68).

Using the GS-10 As a MIDI Interface

When the GS-10 is set to the Advanced driver mode (p. 126, p. 146) and connected via USB, you can use the GS-10’s MIDI IN and OUT connectors to connect your computer to external MIDI devices.

Set the input and output ports used for the computer’s MIDI applications to GS-10 MIDI In/Out.

Section 9

81

Page 81
Image 81
Boss Audio Systems owner manual Recording the GS-10’s Output with a Computer, Running the GS-10 from a Computer