Chapter 1 Playing Sounds

Setting Output Device (Amps) (OUTPUT SELECT)

Select the type of output device connected to the OUTPUT jack or GUITAR AMP OUT jack.

To derive the maximum performance from the GS-10, be sure to make the correct setting for OUTPUT SELECT, the one that’s most suitable for your setup.

2

 

3

1

1.Press [SYSTEM], causing the indicator to light. The Output Select settings screen appears.

2.Turn the PATCH/VALUE dial to select the type of device connected to the OUTPUT jack or GUITAR AMP OUT jack.

Line/Phones

Set this when connecting the OUTPUT jack to an audio set or when connecting a recorder for recording.

Use this setting also when using the GS-10’s speakers or headphones.

Combo AMP

Use this setting when connecting to the guitar input of a combo amp (where the amp and speaker or speakers are combined in a single unit).

Stack AMP

Use this setting when connecting to the guitar input of a stack-type guitar amp (where the amp and speaker or speakers are separated).

Combo Return

Use this setting when connecting to RETURN with a combo amp.

Stack Return

Use this setting when connecting to RETURN of a stack amp or rack mounted power amp.

3.Press [EXIT] to return to the Play screen.

*Set OUTPUT SELECT as shown below, when the PREAMP/ SPEAKER type (p. 29) is set to CONCERT 810, SESSION, BASS 360, T.E., B-MAN, FLIP TOP, Bass Clean, Bass Crunch, Bass HiGain, or Mic Preamp.

When connecting to an audio amp or similar equipment: Line/Phones

When connecting to a guitar amp: Combo Amp or Combo Return

When connecting to a bass amp: Stack Amp or Stack Return

Guitar Tuning

You can use the GS-10’s built-in “tuner function” to tune your guitar.

For instructions on using this function, refer to “Tuning the Guitar” (p. 64).

16

Page 16
Image 16
Boss Audio Systems GS-10 owner manual Setting Output Device Amps Output Select