
5 Brocade DCX 8510-4 chassis removal and replacement
1 | 1 | 1 | 820100 | id | N8 | Online | FC | |
10:00:00:05:33:26:0e:65 |
|
|
|
|
| |||
2 | 1 | 2 | 820200 | id | N8 | Online | FC | |
10:00:00:05:33:48:5e:f5 |
|
|
|
|
| |||
3 | 1 | 3 | 820300 | id | N8 | Online | FC | |
10:00:00:05:1e:f8:a0:b3 |
|
|
|
|
| |||
(output | truncated) |
|
|
|
|
|
4.Verify that all the IP address information is correct by entering ipAddrShow and checking the results against the IP information recorded in the
switch:admin> ipaddrshow
SWITCH
Ethernet IP Address: xxx.xxx.xxx.12
Ethernet Subnetmask: 255.55.0.0
Fibre Channel IP Address: 1.2.3.4
Fibre Channel Subnetmask: 255.255.255.0
CP0
Ethernet IP Address: xxx.xxx.xxx.10
Ethernet Subnetmask: 255.55.0.0
HostName : cp0
Gateway Address: xxx.xxx.xxx.1
CP1
Ethernet IP Address: xxx.xxx.xxx.11
Ethernet Subnetmask: 255.55.0.0
HostName : cp1
Gateway Address: .1
Backplane IP address of CP0 : 10.0.0.4
Backplane IP address of CP1 : 10.0.0.5 switch:admin>switch:admin>
Reconnecting the system to the network and fabric
See the cable routing information recorded in Table 12 for the following steps.
Complete the following steps to reconnect the Brocade DCX
1.Connect the CP blades to the local area network.
a.Insert the appropriate Ethernet cables into each Ethernet port.
b.Connect the other ends to an Ethernet 10/100
NOTE
The Brocade DCX
2. Reconnect the transceivers and cables to the port blades:
104 | Brocade DCX |
|