Brocade Communications Systems DCX 8510-4 manual Diagnostics, Boot

Diagnostics C

•Review the system error log using the errShow or errDump commands.

Any errors detected during POST are written to the system log, which is accessible through the errShow command. For information about error messages, refer to the Fabric OS Message Reference.

POST includes the following steps:

1.Preliminary POST diagnostics are run.

2.Operating system is initialized.

3.Hardware is initialized.

4.Diagnostic tests are run on several functions, including circuitry, port functionality, ability to send and receive frames, all aspects of memory, parity, statistics counters, and serialization.

Boot

In addition to POST, boot includes the following steps after POST is complete:

1.Universal port configuration is performed.

2.Links are initialized.

3.Fabric is analyzed. If any ports are connected to other switches, the Brocade DCX 8510-4 participates in a fabric configuration.

4.The Brocade DCX 8510-4 obtains a domain ID and assigns port addresses.

5.Unicast routing tables are constructed.

6.Normal port operation is enabled.

Diagnostics

Diagnostic tests are automatically run during POST to check the status of the Brocade DCX 8510-4. Any error messages generated during POST are sent to the error logs and to the serial console, if connected.

Diagnostic tests can also be run manually to test and troubleshoot the hardware and the firmware, including internal connections and circuitry, transceivers, and port cables. However, diagnostic tests are generally intended for use by support personnel.

NOTE

Error messages do not necessarily indicate that the Brocade DCX 8510-4 requires maintenance.

Each diagnostic test can be implemented by entering the related command through a Telnet or serial session. For a list of diagnostic tests and commands, refer to the Fabric OS Administrator’s Guide.

Brocade DCX 8510-4 Backbone Hardware Reference Manual	135
53-1002177-05