Control processor blade (CP8) removal and replacement | 5 |
6.If both CP blades are healthy and you want to replace the active CP blade, log in to the active CP blade and run the following steps:
a.Run the haFailover command to make the standby CP blade the active blade. The currently active CP blade becomes the standby blade. Wait until the status LED on the currently active CP blade is no longer lit.
b.Confirm the completion of the failover by running the haShow command.
c.Log in to the new active CP blade.
7.Run firmwareShow to note the firmware version of the active CP blade.
The following example shows the results of the firmwareshow command when the firmware versions on the two CP blades are not the same. Note the warning message at the end of the output.
DCX_120:root> firmwareshow |
| ||
Slot Name | Appl | Primary/Secondary Versions | Status |
4 | CP0 | FOS | v6.4.0a | STANDBY |
|
|
| v6.4.0a |
|
5 | CP1 | FOS | v7.0.0 | ACTIVE * |
|
|
| v7.0.0 |
|
WARNING: The local CP and remote CP have different versions of firmware, please retry firmwaredownload command.
DCX_120:root>
8.Run haDisable from the active CP blade to prevent failover or communication between the CP blades during the replacement.
9.Use the configUpload command to upload the backbone configuration to a specified FTP server. Enter information at the prompts.
a.Run the fosconfig
b.If virtual fabrics are not enabled, run the configupload command. This command uploads the Brocade DCX
Removing a control processor blade (CP8)
For this procedure, please refer to “ESD precautions” and Figure 22.
The chassis continues to operate while a CP blade is being replaced if the redundant CP blade is active and a failover does not occur. You can prevent failover by entering the haDisable command.
Complete the following steps to remove a CP8 control blade (CP).
1.Remove the chassis door.
2.Log in to the active CP as the admin user. You can use a serial cable or Telnet, Web Tools, or Fabric Manager. Determine which CP is active using the haShow command or view the active LED on the front of the CP.
Brocade DCX | 69 |
|
