Displaying a list of multicast groups
TABLE 4 Output of the show ip pim sparse command (Continued)
This field... | Displays... |
|
|
Bootstrap Msg interval | How frequently the BSR configured on the device sends the RP set to the RPs within the |
| PIM Sparse domain. The RP set is a list of candidate RPs and their group prefixes. The |
| group prefix of a candidate RP indicates the range of PIM Sparse group numbers for |
| which it can be an RP. |
| NOTE |
| |
| This field contains a value only if an interface on the device is elected to be the BSR. |
| |
| Otherwise, the field is blank. |
| |
|
|
| |
Number of seconds the candidate RP configured on the Layer 3 switch sends candidate |
| ||
interval | RP advertisement messages to the BSR. Default is 60 seconds. |
| |
|
|
| |
Register Suppress | This is the mean interval between receiving a |
| |
Time | registers to be sent again. A lower value means more frequent register bursts at RP, |
| |
|
| ||
| while a higher value means longer join latency for new receivers. Default: 60 seconds. |
| |
|
|
| |
Register Probe Time | Number of seconds the PIM router waits for a |
| |
| generates another NULL register to the PIM RP. Default is 10 seconds. |
| |
|
|
| |
Register Stop Delay | Register stop message. Default is 10 seconds. |
| |
|
|
| |
Register Suppress | Number of seconds that it takes the designated router to send a |
| |
interval | date to the RP after receiving a |
| |
|
|
| |
SSM Enabled | If yes, |
| |
|
|
| |
SPT threshold | Number of packets the device sends using the path through the RP before switching to |
| |
| the SPT path. Default is 1 packet. |
| |
|
|
| |
SSM Group Range |
| ||
|
|
| |
Route Precedence | The route precedence configured to control the selection of routes based on the four |
| |
| route types: |
| |
| • |
| |
| • | Default route from the mRTM |
|
| • |
| |
| • | Default route from the uRTM |
|
|
|
|
|
Displaying a list of multicast groups
To display PIM group information, enter the following command at any CLI level.
Device(config)# show ip pim group
Total number of groups for VRF
1Group 226.0.34.0
Group member at e2/9: v59
Group member at e1/16: v57
2 Group 226.0.77.0
FastIron Ethernet Switch IP Multicast Configuration Guide | 107 |
|
