Setting the version
To set the robustness for a specified VRF, enter the following commands.
device(config)# ipv6 router pim vrf blue
Syntax: [no] ipv6 router pim [ vrf vrf-name ]
The vrf parameter specifies the virtual routing instance (VRF) specified by the variable
Setting the version
You can use this command to set the MLD version (1 or 2) globally. You can select the version of MLD by entering a command such as the following.
device(config)# ipv6 mld version 1
Syntax: ipv6 mld version version-number
The
To set the global MLD version for a specified VRF, enter the following commands.
device(config)# ipv6 router pim vrf blue
Syntax: [no] ipv6 router pim [ vrf vrf-name ]
The vrf parameter specifies the virtual routing instance (VRF) specified by the variable
Configuring MLD parameters at the interface level
The following MLD parameters can be configured at the interface level:
•Port- version - Specifying a port version on page 200
•
•Tracking - Enabling MLD tracking on an interface on page 201
•Version - Setting the version on an interface on page 201
Specifying a port version
To set the MLD version on a virtual Ethernet interface, enter the following commands as shown in the example.
device(config)# interface ve 10
Syntax: ipv6 mld
Enter 1 or 2 for
Specifying a static group
A multicast group is usually learned when an MLDv1 report is received. You can configure one or more static groups without having to receive an MLDv1 report.
200 | FastIron Ethernet Switch IP Multicast Configuration Guide |
|
