Displaying MLD group information
Displaying MLD group information
To display the list of multicast groups, enter a command such as the following.
device #show ipv6 mld group Total 2 groups
- | Port |
| Intf | GrpCmpV Mode |
| Timer |
Idx Group Address |
|
| ||||
Srcs | + | + |
| |||
e3/1/1 |
| v170 | Ver1 exclude | 221 | ||
1 ff05::4422 |
| |||||
0 | e3/1/1 |
| v170 | Ver2 include | 0 | |
2 ff3f::300 |
| |||||
1 |
|
|
|
|
|
|
Total number of groups 2 |
|
|
|
|
|
|
Syntax: show ipv6 mld [ vrf vrf-name ] group
The vrf parameter allows you to display the list of IPv6 MLD groups for the VRF instance identified by the
The following table displays the output from the show ipv6 mld group command.
TABLE 41 Output from the show ipv6 mld group command
Field | Description |
|
|
IDX | Index for the MLD group. |
|
|
Group Address | IPv6 address of the multicast group. |
|
|
Port | The physical port to which the group belongs. |
|
|
Intf | The routing interface to which the port belongs. |
|
|
GrpCmpV | The version of the MLD group report message. |
|
|
Mode | Indicates if the filter mode of the multicast group is in INCLUDE or EXCLUDE. |
|
|
Timer | The number of seconds the interface can remain in its current mode. |
|
|
Total number of groups | The total number of MLD groups. |
|
|
Displaying MLD definitions for an interface
To display the MLD parameters on an interface, including the various timers, the current querying router, and whether or not MLD is enabled, enter the following command.
Brocade#show ipv6 mld |
| + | |||||
+ | Querier |
|
| ||||
Intf/PortGroups Version |
| Timer V1Rtr Tracking | |||||
Oper Cfg | + | + | |||||
- Self | 0 | 0 | |||||
e1/1/1 | 0 |
| 2 | No Disabled | |||
v40 | 0 |
| 2 | - | 0 | 0 | Disabled |
e3/1/1 | 1 |
| 2 | - Self | No | ||
e2/1/1 | 1 |
| 2 | - Self | 0 | 0 | No |
e1/1/1 | 1 |
| 2 | - Self | 0 | 0 | No |
v50 | 0 |
| 2 | - |
|
| Disabled |
202 | FastIron Ethernet Switch IP Multicast Configuration Guide |
|
