Displaying BSR information
Group member at e2/9: v59
Group member at e1/16: v57
3Group 226.0.120.0
Group member at e2/9: v59
Group member at e1/16: v57
4Group 226.0.163.0
Group member at e2/9: v59
Group member at e1/16: v57
5Group 226.0.206.0
Group member at e2/9: v59
Group member at e1/16: v57
6Group 226.0.249.0
Group member at e2/9: v59
Group member at e1/16: v57
7Group 226.0.30.0
Group member at e2/9: v59
Group member at e1/16: v57
device(config)#
Syntax: show ip pim [vrf vrf-name ] group
The vrf keyword allows you to display PIM group information for the VRF instance identified by the vrf- name variable.
The following table describes the output from this command:
TABLE 5 Output from the show ip pim group command
This field... | Displays... |
Total number of Groups Lists the total number of IP multicast groups the device is forwarding.
| NOTE |
|
| This list can include groups that are not PIM Sparse groups. If interfaces on the device |
|
| are configured for regular PIM (dense mode), these groups are listed too. |
|
|
|
|
Index | The index number of the table entry in the display. |
|
|
|
|
Group | The multicast group address |
|
|
|
|
Ports | The device ports connected to the receivers of the groups. |
|
|
|
|
Displaying BSR information
To display BSR information, enter the following command at any CLI level.
device(config)# show ip pim bsr
PIMv2 Bootstrap information for Vrf Instance :
This system is the Elected BSR
BSR address: 1.51.51.1. Hash Mask Length 32. Priority 255. Next bootstrap message in 00:01:00
Configuration:
Candidate loopback 2 (Address 1.51.51.1). Hash Mask Length 32. Priority 255. Next
RP: 1.51.51.1 group prefixes: 224.0.0.0 / 4
108 | FastIron Ethernet Switch IP Multicast Configuration Guide |
|
