Brocade Communications Systems IPMC5000PEF manual Displaying status of MLD snooping traffic

Displaying status of MLD snooping traffic

Field	Displays
get-mem	The current memory allocation. This number should continue to increase.
size	The size of a unit (in bytes).
init	The initial allocated amount of memory.

NOTE

This number can be increased. (More memory can be allocated if necessary.)

Available vidx The output interface (OIF) port mask used by mcache. The entire device has a maximum of 4096 vidx. Different mcaches with the same OIF share the same vidx. If vidx is not available, the stream cannot be hardware-switched.

Displaying status of MLD snooping traffic

To display status information for MLD snooping traffic, enter the show ipv6 multicast traffic command.

device#show ipv6 multicast traffic
MLD snooping: Total Recv: 32208, Xmit: 166					GSQry: group-source Q, Mbr: member
Q: query,	Qry: general Q,		G-Qry: group Q,
Recv	QryV1	QryV2	G-Qry	GSQry		MbrV1	MbrV2	Leave
VL1	0	0	0		0	31744	208	256
VL70	0	0	0		0	0	0	0
Recv	IsIN	IsEX	ToIN	ToEX		ALLOW	BLOCK	Pkt-Err
VL1	1473	31784	0		1	1	7	0
VL70	0	0	0		0	0	0	0
Send	QryV1	QryV2	G-Qry	GSQry		MbrV1	MbrV2
VL1	0	0	166		0	0	0
VL70	0	0	0		0	0	0

Syntax: show ipv6 multicast traffic

The following table describes the information displayed by the show ipv6 multicast traffic command.

Field Description

QQuery

Qry	General Query
QryV1	Number of general MLDv1 queries received or sent.
QryV2	Number of general MLDv2 snooping queries received or sent.
G-Qry	Number of group specific queries received or sent.
GSQry	Number of group source specific queries received or sent.
MBR	The membership report.
MbrV1	The MLDv1 membership report.

FastIron Ethernet Switch IP Multicast Configuration Guide	59
53-1003085-02