Displaying IPv6 PIM interface information
TABLE 26 Output from the show ipv6 pim sparse command (Continued)
Field | Description | |
|
| |
Number of seconds the candidate RP configured on the Layer 3 switch sends candidate | ||
interval | RP advertisement messages to the BSR. Default is 60 seconds. | |
|
| |
Register Suppress | This is the mean interval between receiving a | |
Time | registers to be sent again. A lower value means more frequent register bursts at RP, while | |
| ||
| a higher value means longer join latency for new receivers. Default: 60 seconds. | |
|
| |
Register Probe Time | Number of seconds the PIM router waits for a | |
| another NULL register to the PIM RP. Default is 10 seconds. | |
|
| |
Register Stop Delay | Register stop message. Default is 10 seconds. | |
|
| |
Register Suppress | Number of seconds that it takes the designated router to send | |
interval | to the RP after receiving a | |
|
| |
SSM Enabled | If yes, | |
|
| |
SPT threshold | Number of packets the device sends using the path through the RP before switching to the | |
| SPT path. Default is 1 packet. | |
|
| |
SSM Group Range | ||
|
| |
Route Precedence | The route precedence configured to control the selection of routes based on the four route | |
| types: | |
| • | |
| • | Default route from the mRTM |
| • | |
| • | Default route from the uRTM |
|
| |
Embedded RP | Indicates whether the embedded RP is enabled or disabled. | |
Enabled |
|
|
|
|
|
Displaying IPv6 PIM interface information
You can display IPv6 PIM multicast interface information using the show ipv6 pim interface command.
device# show ipv6 pim interface ethernet 1/1/7 |
|
|
|
| ||||
+ | - Sparse Mode v2 | + | + | + | ||||
|
|
| ||||||
|
| ModeSt TTL | ||||||
InterfaceGlobal Address | Override | |||||||
Multicast | VRF | DR | Port | ThrBoundary | ||||
| + Designated Router | |||||||
Prio Interval
+ | |||||
SM | Ena | 1 None | |||
| e1/1/1 a141::1 | ||||
default 1 | 3000ms |
|
|
| |
|
| + Itself |
|
|
|
Total Number of Interfaces : 1 |
|
|
| ||
178 | FastIron Ethernet Switch IP Multicast Configuration Guide |
|
