Displaying IPv6 PIM RPF
TABLE 35 Output parameters of the show ipv6 pim mcache command (Continued)
Field | Description |
|
|
Flags | Show the flags associated with the forward entry. |
|
|
slow ports ethe | Shows the forwarding port ID of the mcache entry which is in the software forwarding |
| path. |
|
|
AgeSltMsk | Shows the slot number on which MP expects ingress traffic. |
|
|
L2 FID | Shows the hardware resource allocated for the traffic switched to receivers in the |
| ingress VLAN. |
|
|
DIT | Shows the hardware resource allocated for routed receivers. |
|
|
AvgRate | Shows the average data traffic rate for the mcache entry |
|
|
profile | Shows the profile ID associated with the stream. |
|
|
Forwarding_oif | Shows the number of outgoing interfaces of the mcache entry. |
|
|
immediate_oifs | Shows the local immediate outgoing interface of the mcache entry. |
|
|
blocked_oifs | Shows the PIM Sparse mode blocked outgoing interfaces. |
|
|
L3 (SW) 1 | Shows whether the traffic is switched or routed out of the interface. |
|
|
L3 (HW) 1 | The forwarding entries by using hardware. |
|
|
VLAN associated with the ingress interface. | |
|
|
Displaying IPv6 PIM RPF
The show ipv6 pim rpf command displays what PIM sees as the reverse path to the source. While there may be multiple routes back to the source, the one displayed by the show ipv6 pim rpf command is the one that PIM thinks is best.
device# show ipv6 pim rpf 2008:165::1010 upstream nbr 2006:503::1001 on v503
Syntax: show ipv6 pim [ vrf vrf-name ] rpf ip-address
The vrf parameter allows you to display what PIM sees as the reverse path to the source for a VRF instance specified by the
The
Displaying IPv6 PIM counters
You can display the number of
FastIron Ethernet Switch IP Multicast Configuration Guide | 187 |
|
