PIM Dense

 

Address

 

Address

PortThrBoundary

Prio Interval

 

+----

+

---+-----------------------

+---+---------

+

 

+---------

+---------------

+

-------

+---------

SM

 

Ena Itself

1 None

 

default

 

e1/1/7 30.0.0.1

 

 

13000ms

Total Number of Interfaces : 1

Syntax: show ip pim [vrf vrf-name] interface [ethernet port-numberloopback num ve num tunnel num ]

The vrf keyword allows you to display multicast boundary information for the VRF instance identified by the vrf-namevariable.

The ethernet parameter specifies the physical port.

The loopback parameter specifies the loopback port.

The veparameter specifies a virtual interface.

The tunnel parameter specifies a GRE tunnel interface that is being configured. The GRE tunnel interface is enabled under the device PIM configuration.

The following table describes the output from the show ip pim interface ethernet command.

Field

Description

 

 

Interface

Name of the interface.

 

 

Local Address

IP address of the interface.

 

 

Mode

PIM mode, dense or sparse..

 

 

St

PIM status for this interface, enabled or disabled.

 

 

Designated Router Address, Port

Address, port number of the designated router.

 

 

TTL Thr

Time to live threshold. Multicast packets with TTL less than this threshold value

 

are not be forwarded on this interface.

 

 

Multicast Boundary

Multicast boundary ACL, if one exists.

 

 

VRF

Name of the VRF.

 

 

DR Prio

Designated router priority assigned to this inerface.

 

 

Override Interval

Effective override interval in milliseconds.

 

 

PIM Dense

NOTE

This section describes the "dense" mode of PIM, described in RFC 3973. Refer to PIM Sparse on page 95 for information about PIM Sparse.

FastIron Ethernet Switch IP Multicast Configuration Guide

81

53-1003085-02

 

Page 83
Image 83
Brocade Communications Systems IPMC5000PEF manual PIM Dense