Brocade Communications Systems IPMC5000PEF manual Displaying MLD group information

Displaying MLD group information

Displaying MLD group information

To display default, maximum, current, and configured values for system maximum parameters, use the show default values command. The following output example does not show complete output; it shows only MLD group values.

Device(config)#show default values			Current	Configured
System Parameters	Default	Maximum
MLD-snoop-group-addr	4096	8192	5000	5000

To display MLD group information, enter the show ipv6 multicast group command.

Device#show ipv6 multicast group

p-:physical, ST:static, QR:querier, EX:exclude, IN:include, Y:yes, N:no VL1 : 263 grp, 263 grp-port, tracking_enabled

1	group	p-port	ST	QR	life	mode	source
	ff0e::ef00:a0e3	1/7	N	Y	120	EX	0
2	ff01::1:f123:f567	1/9	N	Y		IN	1

NOTE

In this example, an MLDv1 group is in EXCLUDE mode with a source of 0. The group excludes traffic from the 0 (zero) source list, which actually means that all traffic sources are included.

To display detailed MLD group information, enter the following command.

Device#show ipv6 multicast group ff0e::ef00:a096 detail Display group ff0e::ef00:a096 in all interfaces in details.

p-:physical, ST:static, QR:querier, EX:exclude, IN:include, Y:yes, N:no

VL1 : 1 grp, 1 grp-port, tracking_enabled		p-port	ST	QR life mode source
1	group
	ff0e::ef00:a096	1/7	N	Y 100 EX 0
	group: ff0e::ef00:a096, EX, permit 0 (source, life):
	life=100, deny 0:

If tracking and fast leave are enabled, you can display the list of clients for a particular group by entering the following command.

Device#show ipv6 multicast group ff0e::ef00:a096 tracking

Display group ff0e::ef00:a096 in all interfaces with tracking enabled. p-:physical, ST:static, QR:querier, EX:exclude, IN:include, Y:yes, N:no

VL1 : 1 grp, 1 grp-port,		tracking_enabled	ST	QR life mode source
1	group	p-port
	ff0e::ef00:a096	1/7	N	Y 80 EX 0
	receive reports from	1 clients: (age)

(2001:DB8::1011:1213:1415 60)

Syntax: show ipv6 multicast group [ group-address[ detail ] [ tracking ] ]

To receive a report for a specific multicast group, enter that group address for group-address.

Enter the detail keyword to display the source list of a specific VLAN.

Enter the tracking keyword for information on interfaces that are tracking-enabled.

The following table describes the information displayed by the show ipv6 multicast group command.

Field	Description
group	The address of the IPv6 group (destination IPv6 address).
p-port	The physical port on which the group membership was received.

56	FastIron Ethernet Switch IP Multicast Configuration Guide
	53-1003085-02