Brocade Communications Systems IPMC5000PEF manual RP 1 configuration, IPv4 Multicast Protocols

IPv4 Multicast Protocols

The configuration examples demonstrate the commands required to enable this application. FIGURE 8 Example of a MDSP Anycast RP network

RP 1 configuration

The following commands provide the configuration for the RP 1 router in Figure 8 .

RP1(config)#router ospf

RP1(config-ospf-router)# area 0

RP1(config-ospf-router)# exit

RP1(config)# interface loopback 1

RP1(config-lbif-1)# ip ospf area 0

RP1(config-lbif-1)# ip ospf passive

RP1(config-lbif-1)# ip address 10.0.0.1/32

RP1(config-lbif-1)# ip pim-sparse

RP1(config-lbif-1)# exit

RP1(config)# interface loopback 2

RP1(config-lbif-2)# ip ospf area 0

RP1(config-lbif-2)# ip ospf passive

RP1(config-lbif-2)# ip address 10.1.1.1/32

RP1(config-lbif-2)# exit

RP1(config)# interface ethernet 5/1

RP1(config-if-e1000-5/1)# ip ospf area 0

RP1(config-if-e1000-5/1)# ip address 192.1.1.1/24

RP1(config-if-e1000-5/1)# ip pim-sparse

RP1(config)# interface ethernet 5/2

RP1(config-if-e1000-5/2)# ip ospf area 0

RP1(config-if-e1000-5/2)# ip ospf cost 5

RP1(config-if-e1000-5/2)# ip address 192.2.1.1/24

RP1(config-if-e1000-5/2)# ip pim-sparse

RP1(config)# interface ethernet 5/3

RP1(config-if-e1000-5/3)# ip ospf area 0

RP1(config-if-e1000-5/3)# ip ospf cost 10

RP1(config-if-e1000-5/3)# ip address 192.3.1.1/24

RP1(config-if-e1000-5/3)# ip pim-sparse

RP1(config-if-e1000-5/3)# exit

FastIron Ethernet Switch IP Multicast Configuration Guide	139
53-1003085-02