Canon L6000 manual Users in Canada

USERS IN CANADA

PRE-INSTALLATION REQUIREMENTS FOR CANON FACSIMILE EQUIPMENT

	A.	Location
		Supply a suitable table, cabinet, or desk. See Appendix A for the unit’s
		dimensions and weight.
	B.	Order Information
		1. Provide only a single-line to touch-tone or rotary telephone set
		terminated with a standard 4-pin modular phone plug. (Touch-tone is
		recommended if available in your area.)
		2. Order an RJ11-C modular jack (USOC code), which should be installed
		by the phone company. If the RJ11-C jack is not present, installation
		cannot occur.
		3. Order a normal business line from your telephone company’s business
		representative. The line should be a regular voice grade line or equivalent.
		Use one line per unit.
		DDD (DIRECT DISTANCE DIAL) LINE
		or
		IDDD (INTERNATIONAL DIRECT DISTANCE DIAL) LINE IF
		YOU COMMUNICATE OVERSEAS
N
	Canon recommends an individual line following industry standards [e.g., the 2500
	(touch-tone) or 500 (rotary/pulse dial) telephones]. A dedicated extension off a
	PBX unit without “Camp On” signals is also permissible with your MultiPASS

L6000. Key telephone systems are not recommended because they send non- standard signals to individual telephones for ringing and special codes, which may cause a fax error.

C.Power Requirements

The power outlet should be a three-prong grounded receptacle (Single or Duplex). It should be independent from copiers, heaters, air conditioners, or any electric equipment that is thermostatically controlled. The rated value is 120 volts and 15 amperes. The RJ11-C modular jack should be relatively close to the power outlet to facilitate installation.

NOTICE

The Industry Canada label identifies certified equipment. This certification means that the equipment meets telecommunications network protective, operational and safety requirements as prescribed in the appropriate Terminal Equipment Technical Requirements document(s). The Department does not guarantee the equipment will operate to the user’s satisfaction.

v