Clarity WN=5230-S manual Mechanical Setup, Standard Screen

Clarity Visual Systems

Mechanical Setup

The mechanical setup is broken down into three processes - the physical assembly of the wall, the attachment of cables to each display and the setting of each display’s number, or address, in the wall. The WN-5230-S comes with either a standard screen, an Ultra-Thin Mullion Screen, or a Blackscreen™. (Blackscreen has the same dimensions as the Ultra-Thin Mullion.)

•The standard screen has a mullion about 1/8th inch (3 mm) wide. The mullion is a strip of sheet metal surrounding the screen and holds it in place.

•The Ultra-Thin Mullion Screen, or mullionless screen, does not have the 1/8th inch strip of metal around the screen. The edge of the screen goes right to the edge of the display unit. This makes the lines between display units much less apparent in the finished video wall.

•BlackScreen™, a mullionless screen as above, but with a higher contrast ratio.

Mechanical Setup, Standard Screen

Install the WN-5230-S in the desired position and connect the power and signal cables. See the following section for an explanation of the cabling configuration.

Figure 3 Connecting display units

22September 1999