Clarity Visual Systems
RecallReset
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Active |
|
|
| Saved |
|
| Settings |
|
|
| Memory |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Save
Figure 5 Block diagram of memory system
Factory
Default
Values
Turning off the System
Turning off the Display, Entering Standby Mode
When the OFF button on the remote is pressed, the display will power down and, after about 5 seconds, the STANDBY LED will turn on. When the STANDBY LED is on, the display is in the standby mode and is ready to be turned on again.
Turning off the Main Power Switch
Turn off the main power switch only for servicing or moving the display or if the display will not be used for an extended period of time.
The main power switch on the power module also acts a circuit breaker. If power to the display is lost, check the power/breaker switch by turning it off and then back on.
The power switch is a lighted switch. When it is lit, it indicates that the AC power is applied and the power switch is on.
52September 1999
