Clarity WN=5230-S manual Operation, Power-On

Clarity Visual Systems

Operation

After the displays are installed, use these procedures:

Step 1 - Power-On

Step 2 - Adjust the Input Signal Settings

Step 3 - Adjust the Colors

Step 4 - Save the Settings

Step 1 – Power-On

1. Turn the main power		The Standby LED flashes, indicating the power up cycle
	switch on the power	has begun. Wait approximately 30 seconds until the
	supply to the ON	Standby LED is on and not flashing.
	position
2.	Press the remote	You will hear a ‘beep.” The lamp will come on, but it will
	control ON button to	require a few minutes to fully warm up. There is a built-in
	power up each Display	delay from when you press the remote’s ON button to
		when the lamp starts to ignite. The extent of the delay
		depends on the position of the Unit switch on the rear
		panel.
		GROUP ID numbers are 0-9 and A-F for a total of 16
		different settings. Each number is equal to that number
		times 16. A setting of 3 is equal to 48.
		UNIT ID numbers are 0-9 and A-F for a total of 16
		different settings. Each number is equal to that number
		times one. A setting of C equals 12.
		The Monitor ID number is the combination of the Group ID
		plus the Unit ID. A Group ID number of 2 and a Unit ID
		number of 5 equals a Monitor ID of 37 decimal, 25
		hexadecimal.
		The delay time between an “on” command to the display
		and the ignition of the lamp is approximately 1 seconds
		times the Unit ID number.
3.	Check for normal	Observe the LED on the rear of each unit. When the

32September 1999