WN-5230-S VideoWall User’s Guide
Power Consumption
Typical power consumption of the WN-5230-S is 160 Watts, but the maximum potential of 200 Watts should be used for calculating the load on the power source. At 200 Watts the current draw is approximately 1.7 Amps at 115 VAC (0.9 Amps at 230 VAC).
Voltage Range
The WN-5230-S will operate between 100 and 240 volts AC at 50/60Hz. Since the power module is auto ranging, there is no manual selector switch.
The main power switch on the power module also acts a circuit breaker. If power to the display is lost, check the power/breaker switch by turning it off and then back on.
The power switch is a lighted switch. When it is lit, it indicates that the AC power is applied and the power switch is on.
WARNING Displays that are intended for 240V configuration must have a properly rated power supply cord and attachment plug supplied by the installer.
WARNING If extension cords are used for power, ensure that only 3-prong grounded cords sized to handle system power requirements are used. Using the wrong-size extension cord can cause a fire- safety hazard and can reduce the voltage available to the WN-5230-S. If the extension cord is warm to the touch it is too small and should be immediately removed from operation.
WARNUNG Falls für die Stromversorgung Verlängerungskabel benutzt werden, achten Sie bitte darauf, daß nur geerdete, dreipolige und für die vorgesehene Leistungsaufnahme ausgelegte Netzkabel benutzt werden. Die Verwendung eines unterdimensionierten Verlängerungskabels stellt eine potentielle Feuersgefahr dar und kann dazu führen, daß die für den WN-5230-S Video-Monitor verfügbare Spannung zu gering ist. Falls das Verlängerungskabel sich fühlbar erwärmt, heißt das, daß das Verlängerungskabel unterdimensioniert ist. Es muß dann sofort aus dem Verkehr gezogen werden.
WARNING Hazardous voltages inside the display and power module can shock, burn and cause death. Only the WN-5230-S lamp and air filter are user serviceable. Always turn off and disconnect power before servicing these items. Refer all other service to a qualified service center. Failure to do so could result in electrical shock, ultraviolet radiation burns, contact heat burns, serious injury, or irreparable damage to the WN-5230-S and may void your factory warranty.
